Is your Logik dishwasher showing an error code? Don’t worry this guide will help you understand what the codes mean and how to address them. Below, we’ve broken down the most common error codes, their causes, and the steps you can take to fix them.
Common Logik Dishwasher Error Codes
Error Code | Description | Possible Solution |
---|---|---|
E1 | Longer inlet time | Check water supply, inlet hose, and inlet valve. |
E3 | Heating Fault | Check heating element, thermostat, and filters. |
E4 | Overflow | Check drain hose, pressure switch, and detergent usage. |
E6 & E7 | Open circuit & Short circuit | Inspect the NTC thermistor and PCB. |
E8 | Distributary valve failure | Inspect and replace distributary valve. |
Ec | Washing control system failure | Check motor and control board. |
Ed | Display unit and control system connection failure | Check wiring between display and control board. |
EH | Door does not open/close properly | Inspect door mechanism and motor. |
Important Notes
- Refer to your manual for specific troubleshooting steps.
- Check for blockages, faulty parts, and power issues before seeking repairs.
- Try a reset before calling a technician.
Troubleshooting Tips:
- Check the Water Supply: Make sure the water tap is fully open and that there are no kinks or blockages in the water inlet hose.
- Clean the Filters: Regularly clean the filters to ensure proper water flow and prevent blockages.
- Check the Drain Hose: Make sure the drain hose is not kinked or blocked, and that it is installed at the correct height.
- Reset the Dishwasher: Try turning off the dishwasher for a few minutes and then turning it back on. This can sometimes clear minor errors.
When to Call for Professional Help
If you’ve tried the troubleshooting steps above and the error persists, it’s time to call in a professional. Continuing to use the dishwasher while it’s malfunctioning could lead to further damage.
Ensure you have the dishwasher’s model and serial number ready when contacting a technician for faster service.